Future Fibre Technologies Introduces Secure Point Detection System

TMCNet:  Future Fibre Technologies Introduces Secure Point Detection System

Future Fibre Technologies Introduces Secure Point Detection System

Mar 23, 2012 (Close-Up Media via COMTEX) —
Future Fibre Technologies reported it will launch its new 2 zone fiber optic perimeter intrusion detection system at the ISC West show in Las Vegas.

In a release, the Company noted details of FFT Secure Point detection system:
It is simple to install and delivers a solution for smaller sites without compromising on performance.

In response to the needs of the short perimeter market, the performance features of FFT Secure Point set new standards, taking zoned fiber optic perimeter detection technology ahead of conventional 2 channel PIDS systems of the past.

FFT Secure Point is ideal for the perimeter protection of utility substations, solar farms, storage yards, pumping stations and block valve sites to name a few.

Developed to exceed the performance of traditional 2 channel fiber optic zoned PIDS systems, the key features of FFT Secure Point include:

-Sensitivity – achieved by using interferometric detection techniques rather than less sensitive ‘speckle pattern’ detection technology. This enables FFT Secure Point to be used on almost all fence types and styles including chain link, welded mesh and palisade with the same high levels of detection and effectiveness

-Low cost, low power, and a small form factor, with 2 independent zones per controller. Each zone can be up to 500 meters or 1,600 feet long

-Employs FFT’s signal processing and intelligent algorithms to minimize environmental nuisance alarms

-Designed for out-of-the box installation and setup by laptop with the free wizard configuration software

-Interfacing options – TCP/IP, USB, as well as traditional Form C contacts
-Optional splice free installation of fiber optic cables
-Simple replacement for existing fiber optic intrusion detection systems
-Peace of mind with FFT’s global 24 month Manufacturer’s Warranty
-oinstallation options – can be configured with individual controllers housed in NEMA 4 enclosures in the field, or rack-mounted in a secure control room up to 10km (6 miles) from the perimeter, linked by an insensitive fiber optic lead-in cable

More Information:
((Comments on this story may be sent to newsdesk@closeupmedia.com))

[ InfoTech Spotlight’s Homepage ]

Leave a Reply

Your email address will not be published. Required fields are marked *